L-Acoustics KARA MODULAR WST SYSTEM User Manual

KARA
KARAKARA
KARA
®
®®
®
M
MM
MO
OO
ODULAR
DULARDULAR
DULAR WST
WST WST
WST
®
®®
®
SYSTEM
SYSTEM SYSTEM
SYSTEM
rigging procedures using
rigging procedures using rigging procedures using
rigging procedures using kara
karakara
kara-
--
-minibu
minibuminibu
minibu
VERSION 1.0
KARA_SRM_EN_1-0
w w w . l - a c o u s t i c s . c o m
30
3030
30
8. If not already done, detach both safety slings from the KARA-MINIBU.
9. Lower the array until the bottom SB18 (SB18#4 for example) rests on the ground and the SB18 above (SB18#3
for example) rests onto it.
10. Separate SB18#3 from SB18#2 as follows:
a. Remove a T-BLP from a SB18#2 bottom link point.
b. Rotate the link arm down.
c. Lock the link arm in closed position by re-inserting the T-BLP into SB18#3.
d. Repeat this procedure until all four arms are locked in closed position.
Figure 33: Separating SB18#3 from SB18#2
11. Raise the array until SB18#2 is separated from SB18#3.
12. Attach a dolly board to each of the SB18#3 and SB18#4 subwoofers.
13. Separate SB18#4 from SB18#3 by applying steps 10.
14. Remove SB18#3 and SB18#4 from the rigging location.
15. Lower the array until it rests on the ground.
16. Detach the motor hook(s) or stinger(s) from the KARA-MINIBU shackle(s).
SB18#1
SB18#2
SB18#3
SB18#4
(x4)
c.
b.
a.

L-Acoustics KARA MODULAR WST SYSTEM Specifications

General

Brand	L-Acoustics
Model	KARA MODULAR WST SYSTEM
Category	Enclosure
Language	English