USER’S MANUAL OF LK-330E
LABEL & MARK INDUSTRIES COMPANY
4
Warning: This equipment is fitted with a cutting knife. Do not put
your fingers near it during use. Be careful to keep clear
of the cutting knife during handling.
2. Points of attention
1) The printer shall be put on a flat and stable place.
2) Do not use the printer or store it in hot, damp or heavily polluted places. Besides,
keep it sheltered from sunshine, bright light and heat sources.
3) Do not put the printer in a place which is under the influence of vibration or
impact.
4) Do not allow damp air condensate on the surface of the printer. If there is any
condensate water, do not turn on the printer power supply before the condensate
water disappears.
5) Connect the printer’s power adaptor to a suitable earthed power socket. Avoid
sharing a same power socket with other large dynamos or other equipment that
may give rise to voltage fluctuation.
6) If the printer is expected to be idle for a long time, disconnect the printer from
the power supply.
7) Be careful to avoid introducing water or conducting matters (like metals) into
the printer. Disconnect the power supply immediately in case of such
introduction.
8) Do not print if there is no print material loaded, otherwise the printer rubber roll
and print head may be severely damaged.
9) Disconnect the power supply before making connection or disconnection;
otherwise the printer control circuit may be damaged.
10) Do not attempt to dismantle the printer to repair by yourself. Unauthorized
dismantling or alteration of this printer is prohibited, otherwise the high-voltage
components inside may give rise to fire accident or electric shock.
11) For the benefit of safety, when the “protective cover” is opened the printer will
not work. Therefore, put on the protective cover when printing. During opening
the “protective cover”, do not let any object touch the moving parts of the
printer.
12) In order to avoid getting electric shock, do not plug or unplug any connections
To Next Page
Loading...
