• When using the Recipe Programming Activity it is possible to:
• Press the Tare key to activate the No-Load Tare Function.
• Press the Menu key to select the Special Function Menu.
• Press the Net/Total key to activate the Modify Total Recipe Weight Function.
• Press the ID/Print key for 2 seconds to activate the Identification Code Function.
• Press the Prog./Start key to enter the Recipe Execution Activity.
• Press the Man./Zero key to enter the Manual Weighing Activity.
• Press the ? key to activate the Help Function.
• Use the Data Transfer Function through the optional T-Data8 Plug device or the
optional Label Wireless Linker card.
Recipes programmed by Totals in Load and Unloads
• This Recipe is used to program the weight to be loaded or unloaded in the Ingredients/
Unloads.
Recipes programmed by Animal Number
• This Recipe is used to program the weight by single animal in the Ingredients (the
Recipe does not contain Unloads). Along with the Ingredient weights, the number of
animals must also be set.
Recipes programmed by Animal Number with Divided Unloads
• This Recipe is used to program the weight of the single animal in the Ingredients and
the number of animals to feed in the Unloads. Before setting the Ingredient weight, it is
necessary to set the number of animals to be fed.
• Each Unload can be assigned an Appetite Percentage that allows the amount of feed to
be distributed to each single Animal Group to be reduced or increased, in relation to the
“standard” Recipe programmed. If the Reciping Mode Preference (code 65) is set as
percentage, the Appetite Percentage Function is not available.
Recipes programmed by Animal Number with Divided Unloads Only
• This Recipe is used, when the mixing wagon is already loaded, if it is necessary to
unload it setting the number of animals to feed. With this type of Recipe it is also
necessary to set the Total Weight of the Single Animal.
• Each Unload can be assigned an Appetite Percentage that allows the amount of feed to
be distributed to each single Animal Group to be reduced or increased, in relation to the
“standard” Recipe programmed. If the Reciping Mode Preference (code 65) is set as
percentage, the Appetite Percentage Function is not available.
chApter 3 15
To Next Page
Loading...
Need help?
General