EasyManuals Logo

Label FEED NAVIGATOR User Manual

Label FEED NAVIGATOR
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
4.13.10 - DAILY RECIPE PROGRAMMING
In the Daily Recipe Function, the weight of the Recipe Loads/Unloads
must be programmed with a value that is equal to the total daily ration
(morning and afternoon). This Function gives users greater accuracy in
preparing and distributing feed. The Daily Recipe must be executed in
two phases, one in the morning and one in the afternoon, in a way that
every each execution distributes half of the programmed weight of each
Ingredient/Unload; the morning execution must be executed by distributing
half of the weight programmed, while the afternoon rations are corrected
in accordance with the errors made during the morning execution, taking
into account the actual loaded/unloaded weight of each single Ingredient/
Unload. The distinction between the morning and afternoon execution is
established by two programmable times. The display of a Daily Recipe
is signalled on the display by the lighting up of the g next to the
symbol.
1. Select the [
DEV. ADJ.
] Function on the display and confirm by pressing
the OK key. The [
YES
] or [
NO
] messages will appear on the display
depending on the previously used setting.
2. Select the desired setting by pressing the q z keys.
[
YES
] the Function is active, [
NO
] the Function is not active.
3. Confirm by pressing the OK key. If the [
NO
] setting is selected, the
equipment will return to the Special Function Menu. If however the
[
YES
] setting is selected, the [ M1.hh:mm ] message will appear on
the display, where M1.hh:mm indicates the Morning Start Time in the
format hours:minutes. The hour digits are flashing.
4. Set the desired hour by pressing the q z (e) keys and confirm by
pressing the OK key. The minute digits are flashing.
Use the same procedure to set the desired minutes. When the OK key
is pressed, the [ M2.hh:mm ] message will appear on the display, where
M2.hh:mm indicates the Afternoon Start Time in the format hours:
minutes. The hour digits are flashing.
To program the Afternoon Start Time, use the same procedure as
described above.
5. The equipment will return to the Special Function Menu.
In the Daily Recipes the maximum number of programmable
Ingredients/Unloads is half the number programmed in the Standard
Recipes (not Daily).
chApter 4 61

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Label FEED NAVIGATOR and is the answer not in the manual?

Label FEED NAVIGATOR Specifications

General IconGeneral
BrandLabel
ModelFEED NAVIGATOR
CategoryController
LanguageEnglish