Labrie MINIMAX - Two-Hand Safety System (optional); Prior to Start Up

Safety 33
Figure 2-14 Emergency stop button underneath panic bar
Two-Hand Safety System (optional)
In some jurisdictions, MINIMAX
TM
vehicles having an optional tipper or crusher panel must be
equipped with a two-hand safety system. The purpose of this system, which comprises of two external
controls (a button/handle set or two buttons), is to protect the operator from injury.
The two-hand safety system ensures that the optional tipper/crusher panel becomes active only when
both external controls are used simultaneously. If one of the controls is released, the tipper/crusher
panel stops immediately. This minimizes the risk of the operator getting injured by the equipment.
NOTE: The two-hand safety system is active only when the operator uses the external controls for the
tipper or the crusher panel, no matter if the M
INIMAX
TM
is equipped with an automated arm or
not.
Prior to Start Up
Before starting the vehicle:
1. Make sure no system will engage and/or start to operate as you start the engine.
2. Make sure the shut-off valve on the hydraulic tank is fully open before starting the vehicle
(see Figure 2-15).