86 Operating the MINIMAX
TM
Visual Inspection
Before starting the vehicle, the operator MUST perform a visual inspection of the truck. Ensure the
engine is not running and the parking brake is set.
Ensure the cleanliness of lamps, safety decals, camera lenses, mirrors, windows, and the vehicle in
general.
Ensure that safety equipment is available on board (i.e. fire extinguisher, first aid kit).
Ensure there is no structural damage.
Ensure that there is no unusual wear, distortion, cracking, leaning, leaking on the vehicle.
Ensure that hydraulic oil level (sight gauge on tank) is as recommended (cylinders must be
collapsed).
Ensure that the hydraulic cylinders do not leak, and ensure mounting pins are secure.
Ensure the hydraulic tank shut off valve is fully open.
Ensure there is no mechanical problem: structure, rollers, hinges, door locks, wear items, etc.
Report any defective system to maintenance personnel.
Ensure there are no leaks, cracks or other types of problems on the frame area, fuel tank, hydraulic
tank, air tanks (air tanks must be drained every day), cleaning trap and wheels.
Ensure the tailgate is fully closed, and BOTH tailgate safety pins are in place.
Once the visual inspection is over, you must start the engine to check if the systems are working
properly.
Starting the Vehicle
To start the MINIMAX
TM
:
1. Before starting the engine, check the following items:
1 a. the shut-off valve on the hydraulic tank is fully open (see Figure 2-15);
1 b. the transmission shifter is on neutral;
1 c. the parking brake is on (see Parking Brake on page 80); and
1 d. the hydraulic system is off (see Pump Switch on page 62).
2. Start the vehicle as stated in the chassis manufacturer’s manual.
3. Switch ON the pump to engage the hydraulic system (the air pressure has to be at a minimum of
70 psi). See Pump Switch on page 62.
4. Turn ON all light switches.
5. If required, move the truck to an appropriate area to perform the daily inspection.
6. Report any defective system to the maintenance personnel.
Body Inspection Procedure
Exit the cab to continue your inspection. Bring a rag along to clean all accessible lights, decals, camera
lenses, etc. Check for mechanical problems: rollers, hinges, door-locking mechanisms, wear items,
etc. Report any defective system to the maintenance personnel.
To Next Page
Loading...
Need help?
General
