Operating the MINIMAX
TM
87
Body inspection procedure:
1. Activate the packer for a full cycle.
2. Check the automated arm operation.
3. Check if the tailgate safety pins are in place. Put them in place to lock the tailgate properly.
4. As you walk along the side of the truck, clean all safety decals.
5. Check the frame area, fuel tank and air tanks (air tanks must be drained every day), cleaning traps
and wheels for leaks, cracks or other type of problems.
6. At the front end, check lights and mirrors.
7. Go around and check lights, clean camera lenses, decals, lights, etc.
8. Check for hydraulic leaks.
Arm Inspection Procedure
On a daily basis, perform a visual inspection of the arm, looking for leaks, cracks or premature wear on
the moving parts. Refer to the Lubrication section of the Maintenance Manual for detailed greasing
points.
Figure 4-1
Automated arm
Danger!
Do not stand directly in the path of the arm while performing the inspection.
Warning!
Apply the lockout/tagout procedure at all times. See Locking Out and Tagging Out the
Vehicle on page 35.
To Next Page
Loading...
Need help?
General
