LaCie Network Space MAX - Modify RAID Mode

LaCie Network Space MAX • DESIGN BY NEIL POULTON Administering Your LaCie Network Space MAX
User Manual page 53
4.15.2. Modify RAID Mode
CAUTION : Changing the RAID mode destroys all data stored on
the Network Space MAX. If you have saved data on the drives, back
up data before following these steps.
The Network Space MAX comes in RAID 0 mode. To modify the
RAID mode, click the Change button. Then, choose which RAID
mode and click Apply.
For information you can use to choose an appropriate RAID mode,
see the Dashboard and section 4.15.1. About RAID Modes.
RAID creation times:
To create a RAID 0 array, it take about three minutes. To create a
RAID 1 array, the following chart shows the approximate time:
Total Size Approx. Time
1TB 2 hours
2TB 4 hours
Fig. 85
Fig. 86