2-4 System 824 Training Manual 2/19/98
Step 8 Let’s make a measurement by pressing the
RUN/STOP key: s.
If this is the first time that the 824 has been used, the
following screen will appear to let you know that the
built in clock should be set so that your measurements
will be time and date correlated. If the clock is already
set, or you wish to skip this for now, go to Step 22
Step 9 To set the time, press TOOLS T to access the
clock/timer set feature.
Step 10 Press d to highlight “Clock/Timer”.
To Next Page
Loading...
