2/19/98 Setup S 2-3
The SLM&RTA (SSA) setup is now
active denoted by the SLM+RTA
title at the top of the screen. Notice
that the SLM characters are bolded.
This denotes that the current view
within this operating mode is the
Sound Level Meter. If the reverse sit-
uation is true (RTA characters
bolded), we will need to change the
current View for the sake of this
exercise.
Step 4 Now press the check key: c to proceed with
the SLM&RTA (SSA) setup recall. If another
message appears noting that the Active ID
has change, press r to highlight “No”. Then
press the check key: c to proceed.
Step 5 Press the VIEW V to access the View menu.
Step 6 If SLM is not highlighted, press u until it is.
Step 7 Press c to select the SLM view choice.
To Next Page
Loading...
