2/19/98 Setup S 2-9
In the SLM View, (on-screen param-
eter modification) can be performed
using the u, d, l, r arrow
keys.
Step 23 Press r once and Slow will be highlighted.
Step 24 Now press r (or l) and you will cycle
through the three detector rate options: Fast,
Slow, and Impulse.
After you stop on a desired detector rate option, you
either press the check key c to exit the cycle mode, or
press dto jump to the next screen controlled parame-
ter.
Step 25 Press d for this exercise to get to the fre-
quency-weighting field.
Step 26 Press r (or l) to cycle through the
weighting options (A, C or Flat). Again, press
the check key c to exit the cycle mode, or
press d to jump to the next screen con-
trolled parameter. You can also perform this
same kind of on-screen editing for the Leq
field. Here, you can toggle between Leq, SEL,
Min, Max, and Peak.
To Next Page
Loading...
