Laser Technology TruPulse 200X User Manual

LTI TruPulse 360R User’s Manual Page 9
Copyright (c) [2017] Laser Technology, Inc. All Rights Reserved. Unauthorized duplication, in whole or in part, is strictly prohibited.
Section 3 - Basic Operations
Batteries
Installation
The TruPulse 360R is powered by a 3 Volt Lithium battery
commonly referred to as CR123A or also referred to as CR123.
1. Remove the Battery Compartment Cover by lifting up
the Hinged Tab and turning counter clockwise,
2. Insert the battery negative end (-) first.
3. Re-insert the Battery Compartment Cover and use the
Hinged Tab to turn clockwise.
4. Press down on the Hinged Tab to secure.
Low Battery Warning
The TruPulse 360R monitors the incoming battery voltage. Figure #5
shows the location of the battery status indicator.
• When the voltage drops below 2.2V, the BATT status
indicator flashes every 5 seconds, alternating with the
normally displayed information.
o You should replace the batteries as soon as possible.
• When the voltage drops below 2.0V, the BATT status
indicator stops flashing and is displayed steady. At this
point, system operation is locked.
o You must replace the batteries to return to normal
system operation.
Figure #5
Figure #4

Laser Technology TruPulse 200X Specifications

General

Brand	Laser Technology
Model	TruPulse 200X
Category	Measuring Instruments
Language	English