LTI TruPulse 360R User’s Manual Page 12
Copyright (c) [2017] Laser Technology, Inc. All Rights Reserved. Unauthorized duplication, in whole or in part, is strictly prohibited.
Main Display
888.8.8 Displays messages and measurement results.
Measurement Units
YARDS
METERS
FEET
Distance measurement units.
Selection available in the System Setup Modes.
Note: Only International lasers include meters.
DEGREES
PERCENT
Inclination measurement units.
Selection available in the System Setup Modes
Crosshair
Serves as the aiming point reference, both horizontally and vertically.
Status Indicators
BATT Flashing: battery voltage is low.
Steady: battery voltage is too low for system operation.
Not Visible: battery voltage is within acceptable range.
LASER Visible: laser is firing.
Not Visible: laser is not active.
MULTI Multiple targets have been logged in the Closest or Farthest target mode.
Target Modes
CONT The unit continuously acquires targets and displays measurements while
is held down. The distance to the most recently acquired target is
displayed.
CLOSEST
The unit logs multiple targets while
is held down.
Of the targets acquired, the distance to the closest target displays.
FARTHEST
The unit logs multiple targets while
is held down.
Of the targets acquired, the distance to the farthest target displays.
Filter
‘F’ appears as the left-most character of the Main Display to indicate
Filter Mode is active. Similar to Standard, single shot mode, but the
laser’s sensitivity is reduced so it only detects pulses returned from a
reflector. The optional foliage filter must be used in conjunction with
this mode.
Standard
(No display
indicator)
Standard, single shot strongest target mode.
To Next Page
Loading...
Need help?
General
