LTI TruPulse 360R User’s Manual Page 38
Copyright (c) [2017] Laser Technology, Inc. All Rights Reserved. Unauthorized duplication, in whole or in part, is strictly prohibited.
During the Missing Line Routine:
Press
to re-shoot Shot 1.
Press
to exit the Missing Line Routine.
1. Select your first target and look through the
eyepiece, using the crosshair to aim to your
target. The ML indicator displays steady and
the HD indicator flashes; prompting you to
measure the Horizontal Distance to the first
target.
2. Press-and-hold
. The LASER status indicator
is displayed while the laser is active. The laser
remains active for a maximum of 10 seconds
while acquiring data about the target.
The measured horizontal distance appears in
the Main Display.
3. Once the fire button is released, "SHot2" appears
steady and the HD indicator flashes (with ML
steady); prompting you to measure the Horizontal
Distance to the second target. Looking through the
eyepiece and using the crosshair to aim to the
second target.
4. Press-and-hold
. The LASER status indicator
is displayed while the laser is active. The laser
remains active for a maximum of 10 seconds
while acquiring data about the target. The measured
horizontal distance to the second target appears in
the Main Display.
5. Once you release
, HD and ML are steady and the
calculated horizontal distance of the missing line is
displayed. The measurement flashes one time and then
displays steady until you press any button or the unit
powers off.
Note: Only International lasers include meters.
At this time, you can:
Press
or to scroll and see the other missing line measurements results (VD, SD, INC,
and AZ).
Reshoot Shot 2 by pressing
or until Shot 2 and ML appear steady in the display as well
as HD flashing, prompting you to measure the horizontal distance to the second target (or new
target). Go to #4 above.
Press
to exit the missing line results and return to Shot 1.
Figure #24
To Next Page
Loading...
Need help?
General
