Output channel: CH1
Output type: sine wave
Drag the CH1 amplitude slider to change the output amplitude.
Drag the CH1 frequency slider to change the output frequency.
X is used to change the output quantity of sine wave x. Y is used to change the
output quantity of the straight line y.
*Remarks: X indicates how many sine waves are output at a time. Y indicates how
many linear voltages are output after the output of X (the period of X sine wave is 1).
The values of X and Y are determined by the actual hardware parameters.
Take X=8 and Y=2 as an example, as shown in the following figure.
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
To Next Page
Loading...
