2)
Magneto-electric camshaft position sensor
Output channel: CH1
Output type: sine wave
Drag the frame slider to change the total number of frames that is output at a
time.
Drag the frequency slider to change the output frequency.
Turn the knob of CH1 PEAK to change the amplitude value.
*Remarks: Phase is the clock. The frame number indicates how many clock-
corresponding waveforms are output at a time (for example, for 50 frames, 50
waveforms will be output cyclically). The waveform corresponding to the upper CH1 is
compatible (there are positive sine wave, reverse sine wave, linear voltage). Users can
edit them as required (the specific parameters are determined by hardware
parameters). For details, see Timing waveform.
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
To Next Page
Loading...
