LeapFrog 3d printer - Page 27

Manual Leapfrog Creatr
27 Leapfrog BV
Click on Heat Extruder. The extruders need to be heated in order for the filament to melt to enable you
to print your object. Depending on your print, select to heat one or two extruders.
 Set the temperature for the printbed. This temperature also differs for each filament type and
should be set up the following way:
ABS: 80 C
PLA

Set the temperature and click Heat Printbed”. The printbed needs to be heated in order for the
filament to stick on the printbed.