Manual Leapfrog Creatr
54 Leapfrog BV
A g-code is now being created to print your model. This may take a few minutes. When the slicing
finishes the software will ask you if you would like to open the G-code file for previewing. It is
advised to always check the preview to make sure the slicing went correctly and as desired.
It may take a short while to open the preview in the 3D display.
When have verified that the g-code has been created as desired and want to start the print on
your Creatr you can stop the preview by clicking Stop Preview, which has replaced the
Preview-button in the Processes menu.
To Next Page
Loading...