Manual Leapfrog Creatr
55 Leapfrog BV
A message will pop up asking you if you would like to begin building it on your platform. When
you click Yes the machine control panel will open and your print job will be started. If you click
No you can always start your job later following the steps in the I have a g-code-section since
you have created the g-code already.
N.B.: Dont forget to preheat the extruder(s) and the heated bed. This will save you time and
manually extruding a bit of filament before running your job will prevent clogging.
To Next Page
Loading...