204 WM-OM-E Rev I
Phase Phase difference between signal
analyzed and signal used as
reference. You can set the output
type to percent, degrees, or
radians. After setting up the
reference, touch the More tab for
signal setups.
Phase difference between
signal and reference
Standard parameter.
Pj Periodic component of jitter Available with SDA
option.
Power Factor Ratio of real to apparent power Available with PMA2
option.
PW50 Average pulse width at the 50%
point between the local baseline
and the local peak or trough.
Hysteresis argument
used to discriminate
levels from noise in
data.
Available with DDM2
option.
Standard in
DDA-5005A.
PW50- Average pulse width at the 50%
point between the local baseline
and the local trough.
Hysteresis argument
used to discriminate
levels from noise in
data.
Available with DDM2
option.
Standard in
DDA-5005A.
PW50+ Average pulse width at the 50%
point between the local baseline
and the local peak.
Hysteresis argument
used to discriminate
levels from noise in
data.
Available with DDM2
option.
Standard in
DDA-5005A.
Real Power Mean of the product of voltage and
current waveform (or mean of the
instantaneous power)
Available with PMA2
option.
To Next Page
Loading...
