Some models have Table and Zoom LED indicators along with
Adjust. Others have only an Adjust LED with Zoom and Table
buttons containing backlit LEDs.
ZOOM AND TABLE BUTTONS
The Zoom and Table buttons may (or may not) provide additional control
for a specific WavePilot funciton you have selected.
Zoom Button
With the Zoom button selected (for a function that has the Zoom
control) you can twist the SuperKnob dial to adjust the zoom value for
your displayed waveform.
Table Button
With the Table control selected (for a function that has the Table control)
you can joystick up or down to Page Up or Down through the table
results. You can also twist the SuperKnob dial to sequentially navigate
each row of the table results.
The remaining topics in this section provide more detail when operating
specific function buttons on the WavePilot Control Area and when using
the SuperKnob.
CURSORS
Use the SuperKnob to adjust Cursors by pressing the Cursors function
button. Once pressed, the Cursors Help Flyout menu is shown.
Note: For more information about the use of Cursors, see Measuring
with Cursors (on page 102).
Horizontal, Off, and Vertical
Pressing the Cursor Function button moves through states for Horizontal
Absolute, Horizontal Relative, Vertical Absolute, Vertical Relative, and
Off.
LED's surrounding the SuperKnob provide visual indication of cursor
status as follows:
When opposing LED's (Top/Bottom and Left/Right) are lit, the
cursors are in a Relative state.
To Next Page
Loading...
