When no LED's surrounding the SuperKnob are lit, the cursors are
in an Absolute or Off state.
Using the SuperKnob with Cursors
The SuperKnob joystick is used for cursor control while in Horizontal and
Vertical states in the following manner:
Horizontal - Cursors Help Flyout menu is shown with instructions
for left and right joystick use of the SuperKnob described as
Leftmost and Rightmost. When either is selected, you can twist
the SuperKnob to adjust the respective cursor.
Vertical - Cursors Help Flyout menu is shown with instructions for
left and right joystick use of the SuperKnob described as Topmost
and Bottommost. When either is selected, you can twist the
SuperKnob to adjust the respective cursor.
Pushing the SuperKnob button changes the cursor control from
the two available states with the added state of tracking (moving
the pair together in parallel).
You can force cursors to swap identities in the event where one is
adjusted past the level of its other extreme. Meaning, if you were
to adjust a bottommost cursor above its respective topmost
cursor, the bottommost would then become the topmost and vice
versa.
Note: Zoom and Table buttons are not used for Cursors.
DECODE
When first pressing the Decode function button, the Serial Decode dialog
is shown. Subsequent presses of the Decode function button produce the
following results:
If you haven't enabled a Decode signal, it Closes the Serial Decode
dialog.
If you have enabled a Decode signal, it Closes the Serial Decode
dialog and disables the Decode signal.
If you have enabled a Decode signal, and the Serial Decode dialog
is closed or a different dialog is currently opened (say, the Zoom
dialog), the Serial Decode dialog is Opened.
To Next Page