LEGOtheLEGOlogoMINDSTORMSandtheMINDSTORMSlogoaretrademarksofthe/sontdesmarquesde
commercedu/sonmarcasregistradasdeLEGOGroup©TheLEGOGroup
LEGOeducation.com
Delete blocks
If you want to delete a block from a program, highlight the block
you want to delete and press the Up button to go to the Block Palette.
In the Block Palette, navigate to the waste bin on the far left and
press the Centre button. The block is now deleted.
Run program
To run your program, use the Left button to navigate to the Start
block at the very beginning of the program. Press the Centre button
and your program will run.
Save and open program
To save your program, navigate to the Save icon on the far left of
your program. When clicking on the Save icon, you will be asked to
name your program or accept the default name. Once you are done,
click OK and your program is now saved in the BrkProg_SAVE folder
that can be accessed from the File Navigation screen (please refer
to page 30).
You can also open any existing EV3 Brick Program by clicking on
the Open icon located above the Save icon. Use the Up and Down
buttons to toggle between those two icons.
EV3 Brick Interface
Delete block
Run program
Save program
EV3 TECHNOLOGY
To Next Page
Loading...
Need help?
General
