LEGOeducation.com
NOTE:
The EV3 Brick only
supports the following
network encryption
modes: None and
WPA2.
Wireless – Wi-Fi
Your first step in connecting to Wi-Fi is to acquire a Wi-Fi USB dongle.
For a list of compatible dongles, ask your local LEGO
®
Education
provider or go to the official LEGO MINDSTORMS
®
Education website
(www.LEGOeducation.com/MINDSTORMS).
To begin the setup, you must have access to a wireless network,
and know the network’s name and its password.
If the EV3 Software is open, close it and insert your Wi-Fi dongle
into the EV3 Brick using the USB Host port.
Before you can connect the EV3 Brick to a network, you will need
to enable Wi-Fi on the EV3 Brick. Directions for this can be found
on page 40.
Settings screen
NOTE:
Because of keyboard limitations,
the password for the network must be
made up of numbers, capital letters, and
lowercase letters. You will not be able
to use some symbols, such as the
# sign, or letters and symbols
from non-Latin alphabets.
Connecting the EV3 Brick to Your Computer
EV3 TECHNOLOGY
To Next Page
Loading...
Need help?
General
