LEGRAND CS102 - Page 50

CS102 SNMP Card
User Manual
50
3. Enter the related SNMP setting as shown below.
============================================================
Network Control Group
[SNMP Control Group]
============================================================
1. SNMP Control :
Enabled
2. SNMP Port :
161
3. On Battery Trap Repeat Time :
1
0. Return to previous menu
Please Enter Your Choice =>
After completing these settings, press “0” to return to the previous menu.
4. Enter the related SMTP setting as shown below.
============================================================
Network Control Group
[SMTP Control Group]
============================================================
1. SMTP Control :
Enabled
2. SMTP Port :
25
0. Return to previous menu
Please Enter Your Choice =>
After completing these settings, press “0” to return to the previous menu.
5. Enter the related SSH setting as shown below.
============================================================
Network Control Group
[SSH Control Group]
============================================================
1. SSH Control :
Disabled
2. SSH Port :
22
0. Return to previous menu
Please Enter Your Choice =>
After completing these settings, press “0” to return to the previous menu, then press “0” again
to return to the main configuration menu.