LEGRAND CS102 - Page 52

CS102 SNMP Card
User Manual
52
3. Press “2” to enter the related access control setting as shown below.
============================================================
Account Control Group
[Access Control Table]
============================================================
User Name User Password
User Level
-------------------------------------------------------------------------
[1] *
Disabled
[2] *
Disabled
[3] *
Disabled
[4] *
Disabled
[5] *
Disabled
[6] *
Disabled
[7] *
Disabled
[8] *
Disabled
Command :
1. Display one entry
2. Modify one entry
0. Return to previous menu
Please Enter Your Choice =>
After completing these settings, press “0” to return to the previous menu.
4. Press “3” to enter the related super user setting as shown below.
============================================================
Super User Name & Password Group
[Super User Group]
============================================================
1. User Name :
admin
2. User Password :
*
0. Return to previous menu
Please Enter Your Choice => 0
After completing these settings, press “0” to return to the previous menu, then press “0” again
to return to the main configuration menu.