Description of fields
Field Option Description
Pre-/Suffix Only used for the Setout app.
Prefix Adds the character entered for Identifier in
front of the original point number of the
point to be staked.
Suffix Adds the character entered for Identifier at
the end of the original point number of the
point to be staked.
Off The staked point is stored with the same
point number as the point to be staked.
Identifier Editable field Only used for the Setout app.
The identifier can be up to four characters
and is added at the start, or end, of a point
number of a point to be staked.
Setout Beep On The instrument beeps when the distance
from the current position to the point to be
staked is ≤ 0.5 m.
The closer the prism is to the point to be
staked the faster the beeps will be.
Off Beep is deactivated.
Filter Off No filter is active
Nearest Searches the job for points close to the cur-
rent position. The points are selected as the
points to be staked. After staking and storing
the first nearest point, the next nearest point
is suggested for staking out.
The app algorithm sorts the points according
to the minimum walking distance in all direc-
tions to each point.
Radius Shows points within the defined radius from
a particular point. The radius is the horizontal
distance.
PtId Range Shows points with point IDs between the
entered start and end ID.
Centre Point Editable field The point to which the radius is applied.
Available for Filter: Radius.
Radius Editable field The radius of the circle within which the
points are shown. Available for Filter:
Radius.
From Editable field The first point to be displayed. Available for
Filter: PtId Range.
To Editable field The last point to be displayed.Available for
Filter: PtId Range.
Setout Settings
82 Apps
To Next Page
