5.4006.8501.0 B
8-8 Troubleshooting
Alarm code and message Description / cause Recovery procedure
5. If the problem remains, call your
local Lely service provider.
29 NO_GYRO_START
1. Call your local Lely service provider.
30 M1 THERMISCH
Motor 1 thermic out
• Current left motor too
high, probably due to dirt
or worn parts.
1. Remove any dirt or obstacles.
2. Make sure there are no worn parts
(manure scraper, sliding disk).
31 M2 THERMISCH
Motor 2 thermic out
• Current right motor too
high, probably due to dirt
or worn parts
1. Remove any dirt or obstacles.
2. Make sure there are no worn parts
(manure scraper, sliding disk).
32 COOL DOWN
• Machine pauses to cool
down the motors.
1. Remove any dirt or obstacles.
2. Make sure there are no worn parts
(manure scraper, sliding disk).
3. If the alarm is repeated more than 5
times a week, call your local Lely
service provider.
33 FULL CHARGING
• Not enough charging time
between routes. The
machine must recharge
fully during nighttime.
1. Modify the routes (see Modify a
Route on page 5-27).
2. Make sure the time period between
the routes is long enough to fully
recharge the battery.
35 BATT ERROR
• Battery recharge failed,
too low charging current.
• Bad contact with battery
charger due to dirt and/or
corrosion.
• Loose connections.
1. Clean the Charging Strips and the
Charging Electrodes (see page 6-2).
2. Make sure the Battery is Charging
(see page 7-5).
37 GYROANGLEFACT
1. Call your local Lely service provider.
38 LOADING
No charging current! Check
charge strips for dirt
• Bad contact with battery
charger due to dirt and/or
corrosion.
• Loose connections
1. Clean the Charging Strips and the
Charging Electrodes (see page 6-2).
2. Make sure the Battery is Charging
(see page 7-5).
3. Charge the machine.
39 GYRO_TEMP
1. Call your local Lely service provider.
41 COM_BATTCHAR2
• Gyro calibration failed.
1. Try again.
in n o vato rs in ag ricu ltu r e
To Next Page
Loading...