LEM DX 26 PLUS - Dump out PRESET; Incoming Dump

25
Dump Out PRESET
This menu page allows to download a PRESET via the serial ports.
This allows to immediately “copy” the settings of the various PRESETS of a DX 26 PLUS to another DX
26 PLUS.
Dum
p
Out Preset
2U 2x2
W
+2M
A
X
To download a PRESET:
☞ Use DIAL to reach the required PRESET.
☞ Press ENTER.
N.B.: the menu page remains unchanged to allow other PRESETS to be dumped.
All the Preset’s data (name, configuration, parameter values, etc.) are immediately transmitted to the
units connected to the serial ports (other DX 26s, computers, etc.).
N.B.: in order for the transfer to have effect, the receiving units must be able to identify and accept Incoming Dump
operations.
When two or more DX 26s are connected, the PRESET sent by the transmitting DX 26 PLUS (TX)
overwrites (and therefore cancels) the existing PRESET in the same memory position of the receiving
DX 26s (RX).
DX 26 #1 DX 26 #2 DX 26 #3 DX 26 #4
Dump Out Pre se
t
Incoming Dump Incoming Dump Incoming Dump
SEND
DUMP
ACCEPT
DUMP
IGNORE
DUMP
ACCEPT
.. .. .. ..
Preset #2 #2 MySetup #2 SideField #2 Default
Preset #3 #3 MySetup5 #3 Concert1 #3 Default
Preset #4 #4 LiveSet #4 Concert2 #4 Default
Preset #5 Preset #5 #5 Concert3 Preset #5
Preset #6 #6 Monitor #6 Concert4 #6 Default
Preset #7 #7 Monitor2 #7 Remote1 #7 Default
Preset #8 #8 Monitor3 #8 Remote2 #8 Default
Preset #9 #9 Side #9 Remote2 #9 Default
.. .. .. ..
SERIAL PORT SERIAL PORT SERIAL PORT
Incoming Dump
Allows to accept or ignore the Dump of a PRESET sent from another DX 26 PLUS or from a
computer via serial ports. Settings can be:
Ignore the data received via the serial ports. Accept the data received via the serial ports.
Incomin
g
Dum
p
I
g
nore
Incomin
g
Dum
p
A
cce
p
t
PRESET menu