45
Output Meters
Allows to decide whether to display the outputs’ signal before or after MUTE.
The options include:
PreMute PostMute
the signal is always shown the signal is only shown if
no matter what the MUTE status the output isn’t in MUTE
Out
ut Meters
PostMute
Temperature
Allows to key in the value of the environmental temperature of place of installation.
The system uses this value to automatically compensate for the differentials due to the difference
speed of sound transmission according to the air temperature.
This allows to set the delays during the sound-check and only have to reset them automatically
when necessary (for example during a concert, in the event of big jumps in temperature, etc.).
The editing values are in the following ranges: +60°C ÷ -30°C with 1°C steps
140.0°F ÷ -22.0°F with 1.8°F steps
Tem
erature
68.0°F
N.B.: the measurement units can be chosen between °C (degrees Centigrade) and °F (degrees Fahrenheit) by means
of the Temperature Unit function (UTILITY menu - Units submenu).
UTILITY menu
To Next Page
Loading...
