LEM DX 26 PLUS - Comm. Setup Submenu; PRESET Change RX

50
COMM. SETUP SUBMENU
Comm. Setup Preset Change RX
This submenu allows access to the setting of communication with other units via the serial ports.
N.B.: the Dump Out PRESET and Incoming Dump functions are an exception, as they’re controlled directly in the
PRESET menu.

Comm. Setu
p
PRESET Change RX
Allows to accept or ignore the PRESET Change command sent via the serial ports from a computer
or another DX 26 PLUS when it loads a PRESET.
The settings can be:
Ignore PRESET Change commands received.Accept and execute PRESET Change commands.
Preset Chan
g
eRX
Acce
p
t
Preset Chan
g
eRX
I
g
nore
The PRESET Change command is completely identical to MIDI Program Change: the transmitting
unit sends an instruction containing a number of PRESETS to load; the receiving units (if they are
able to accept the command) each loads into its own memory the PRESET with the corresponding
number.
This means that, in a chain of DX 26 PLUS, all the units set with “PRESET Change RX = Accept”
load the same number of PRESET, in spite of the fact that it corresponds to PRESETS with different
contents in the various units.
N.B.: to transmit the same contents, the PRESET Dump function is used.
DX 26 #1 DX 26 #2 DX 26 #3 DX 26 #4
Load Preset Preset Change RX Preset Change RX Preset Change RX
SEND ACCEPT IGNORE ACCEPT
.. .. .. ..
Preset #2 #2 MySetup #2 SideField #2 Default
Preset #3 #3 MySetup5 #3 Concert1 #3 Default
Preset #4 #4 LiveSet1 #4 Concert2 #4 Default
Preset #5 #5 LiveSet2 #5 Concert3 #5 Default
Preset #6 #6 Monitor #6 Concert4 #6 Default
Preset #7 #7 Monitor2 #7 Remote1 #7 Default
Preset #8 #8 Monitor3 #8 Remote2 #8 Default
Preset #9 #9 Side #9 Remote2 #9 Default
.. .. .. ..
SERIAL PORT SERIAL PORT SERIAL PORT
UTILITY menu