LEM DX 26 PLUS - Input Noise Gate

30
Input Noise Gate
Noise reduction filter onthe inputs.
Aloows to cut or reduce the background noise generated by the unit connected to the processor’s
inputs (the mixer, for example). The filter is active when the input signal is below a certain threshold
and reduce its level cutting the undesired background noises.
´
Noise Gate
The following editable parameters are available, in two different pages:
Noise Gate ON/OFF
IN
A
Gate On
A
T1.0ms RL0.50S
Reaction times
Allows to set the Noise Gate attack and release times.
 ATTACK (AT) is the time needed by the filter to bring back the signal to its normal level when it
goes above the threshold.
 RELEASE (RL) is the time needed by the filter to cut the signal once it goes below the threshold.
IN
A
Gate On
A
T1.0ms RL0.50S
Threshold
Allows to set the threshold level: if the signal goes below this threshold the Noise Gate reduces the
level.
The editing values are within the following ranges: +8dBu ÷-60dBu, with 2dBu steps
Range
Allows to set the amount of the signal level reduction.
The editing values are within the following ranges: 0dBu ÷-80dBu, with variable steps
IN
A
Gate On
THR-60.0 RG-80.0
EDIT menu