Lenovo ThinkSystem DG5000 - Page 64

If your system has...
Then...
A network connection
1. Press y when prompted to restore the
backup configuration.
2. Set the healthy node to advanced privilege
level:
set -privilege advanced
3. Run the restore backup command: system
node restore-backup -node local -target-
address impaired_node_IP_address
4. Return the node to admin level: set
-privilege admin
5. Press y when prompted to use the
restored configuration.
6. Press y when prompted to reboot the
node.
No network connection
1. Press n when prompted to restore the
backup configuration.
2. Reboot the system when prompted by the
system.
3. Select the Update flash from backup
config (sync flash) option from the
displayed menu.
If you are prompted to continue with the
update, press
y.
No network connection and is in a
MetroCluster IP configuration
1. Press n when prompted to restore the
backup configuration.
2. Reboot the system when prompted by the
system.
3. Wait for the iSCSI storage connections to
connect.
You can proceed after you see the
following messages:
date-and-time [node-name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected for the target
iSCSI-target (type: dr_auxiliary, address: ip-address).
date-and-time [node-name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected for the target
iSCSI-target (type: dr_partner, address: ip-address).
date-and-time [node-name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected for the target
iSCSI-target (type: dr_auxiliary, address: ip-address).
date-and-time [node-name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected for the target
iSCSI-target (type: dr_partner, address: ip-address).
4. Select the Update flash from backup
config (sync flash) option from the
displayed menu.
If you are prompted to continue with the
update, press
y.
58
ThinkSystem DG5000 Hardware Installation and Maintenance Guide