Table 1. Server specifications (continued)
Specification
Description
Storage controllers Support for JBOD mode and RAID level 0, 1, 10:
• 530-16i PCIe 12Gb SFF RAID adapter (Gen3)
Support for JBOD mode and RAID level 0, 1, 5, 10, 50:
• 530-8i PCIe 12Gb SFF RAID adapter (Gen3)
Support for JBOD mode and RAID level 0, 1, 5, 6, 10, 50, 60:
• 930-8i 2 GB Flash 12Gb SFF RAID adapter (Gen3)
• 930-16i 4 GB Flash 12Gb SFF RAID adapter (Gen 3)
• 940-8i 4 GB Flash 12Gb SFF RAID adapter (Gen4)
• 940-8i 8 GB Flash 12Gb SFF RAID adapter (Gen4)
• 940-16i 8 GB Flash 12Gb SFF RAID adapter (Gen4)
• 930-8e 4 GB Flash 12Gb SFF RAID adapter (Gen3)
• 940-16i 8 GB Flash 12Gb Internal CFF RAID adapter (Gen4)
• 940-32i 8GB Flash 12Gb SFF RAID adapter (Gen4)
Support the following HBA adapter:
• 430-8i SAS/SATA 12Gb SFF HBA adapter (Gen3)
• 430-16i SAS/SATA 12Gb SFF HBA adapter (Gen3)
• 430-8e SAS/SATA 12Gb SFF HBA adapter (Gen3)
• 430-16e SAS/SATA 12Gb SFF HBA adapter (Gen3)
• 440-16e SAS/SATA 12Gb SFF HBA adapter (Gen4)
• 440-16i SAS/SATA 12Gb Internal CFF HBA adapter (Gen4)
Support the following RAID expander adapter:
• 36i 12Gb Internal CFF RAID Expander
Notes:
• SFF: Standard Form Factor. This type of RAID/HBA adapter is installed in the PCIe slots
on the rear of the server.
• CFF: Custom Form Factor. This type of RAID/HBA adapter is installed on the chassis
between fans and front backplane.
• CFF RAID/HBA Expander: Custom Form Factor. This type of Expander receives signals
from CFF/SFF RAID/HBA adapters and used for SAS/SATA configurations only. It is
installed next to the CFF RAID/HBA adapter on the chassis between fans and front
backplane.
For technical rules for storage controllers, see “” on page .
System fans
• Up to six hot-swap system fans (N+1 redundancy, one redundant fan)
• Supported fan types:
– Standard fan 6038 (single-rotor 17000 RPM)
– Performance fan 6056 (rual-rotor 18000 RPM)
For technical rules for system fans, see “Technical rules for system fans” on page 148.
Chapter 1. Introduction 5
To Next Page
Loading...
