GPUs
Use this section to understand the routing for GPUs.
Figure 14. Cable routing for single-wide and double-wide GPU
From To
1 Power connector on a single-wide GPU (on riser 3
assembly)
GPU 1 connector on the system board
2 Power connector on a double-wide GPU (on riser 1 or
2 assembly)
GPU Pwr connector on the riser card (on riser 1 or 2
assembly)
Riser cards
Use this section to understand the cable routing for riser cards.
The server supports up to three riser cards: riser card 1, riser card 2, and riser card 3. Among which, only
riser card 3 needs cable connections:
•
“Riser card 3 power and sideband connection” on page 60
• “Riser card 3 (x8/x8 or x16/x16 PCIe) cable connection” on page 61
The riser card types vary by server model. For detailed information, see “Rear view” on page 33.
Chapter 3. Internal cable routing 59
To Next Page
Loading...
