Install the cable wall brackets
Use this information to install the full-height or half-height cable wall brackets.
About this task
Your server supports two full-height or half-height cable wall brackets on the left and right side of the system
board. The illustration shows the installation of the full-height cable wall brackets, the installation method of
the half-height cable wall brackets is the same.
Attention:
• Read “Installation Guidelines” on page 129 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
• Youku: http://list.youku.com/albumlist/show/id_52339612.html
158 ThinkSystem SR665 Maintenance Manual
To Next Page
Loading...
