Procedure
Step 1. Touch the static-protective package that contains the new cable holder to any unpainted surface
on the outside of the server. Then, take the new cable holder out of the package and place it on a
static-protective surface.
Step 2. Install the cable wall brackets.
Figure 53. Cable wall brackets installation
C
a. Align the two holes on the system board. Install the brackets to the system board as shown.
b. Install the two screws to secure the brackets.
After you finish
1. Connect any cables. See Chapter 3 “Internal cable routing” on page 57.
2. Complete the parts replacement. See “Complete the parts replacement” on page 397.
Chapter 4. Hardware replacement procedures 159
To Next Page
Loading...
