Procedure
Figure 118. Processor removal
Step 1. Use a Torx #T20 screwdriver to loosen the captive screws in the removal sequence shown on the
force frame.
Note: Use an ESD safe screwdriver and set the maximum torque value to 14.0 ± 0.5 inch-pounds.
Step 2. Slightly lift up the force frame and the rail frame in the direction shown. The processor in the rail
frame is spring-loaded.
Step 3. Hold the blue tab of the processor carrier and slide the processor carrier out of the rail frame.
After you finish
Install a new processor. See “Install a processor” on page 271.
270
ThinkSystem SR665 Maintenance Manual
To Next Page
Loading...
