Procedure
Figure 119. Processor installation
Step 1. Slide the processor and carrier into the rail frame.
Step 2. Push the rail frame down until the blue latches lock into place.
Step 3. Close the force frame.
Step 4. Tighten the screws in the installation sequence shown on the force frame.
Note: Use an ESD safe screwdriver and set the maximum torque value to 14.0 ± 0.5 inch-pounds.
After you finish
Install the heat sink. See “Install a heat sink” on page 273.
272
ThinkSystem SR665 Maintenance Manual
To Next Page
Loading...
