Procedure
Step 1. Touch the static-protective package that contains the new riser card to any unpainted surface on
the outside of the server. Then, take the new riser card out of the package and place it on a static-
protective surface.
Step 2. Remove the top cover. See “Remove the top cover” on page 392.
Step 3. If there is any PCIe adapter installed on the riser card, record the cable connections first. Then,
disconnect all cables from the PCIe adapter.
Step 4. Remove the riser 3 assembly in the direction as shown.
Figure 170. Riser 3 assembly removal (two-slot riser bracket)
356 ThinkSystem SR665 Maintenance Manual
To Next Page
Loading...
