Lenovo ThinkSystem SR860 V2 - Page 199

– Nvidia Tesla V100s
– Nvidia Tesla T4
– 1610-8p NVMe switch adapter
• The following adapters must be installed in the PCIe riser assembly or 4U PCIe riser cages. See
“Install an
adapter in the PCIe riser assembly” on page 191
or “Install an adapter into a 4U PCIe riser cage” on page
257
for installation instructions.
– ThinkSystem Broadcom 57454 10/25GbE SFP28 4-port PCIe Ethernet Adapter
– ThinkSystem Broadcom 57454 10/25GbE SFP28 4-port PCIe Ethernet Adapter V2
Install an adapter on the system board
Procedure
Step 1. Open the retention latch.
Step 2. If a filler has been installed in the PCIe slot, remove the screw that secures it, and remove the filler.
Step 3. Align the adapter with the connector on the system board, and push it in.
Figure 80. Installing an adapter to the system board
Step 4. Secure the adapter with a screw.
Step 5. Close the retention latch.
Install an adapter in the PCIe riser assembly
Procedure
Chapter 4. Hardware replacement procedures 191