Lenze 9300 vector Series User Manual

Configuration
Function blocks
Diameter calculator (DCALC)
8
8.2
8.2.1

8.2-2
EDSVF9333V EN 3.0-06/2005
IMPORTANTPossible settingsCode
SelectionLenzeNameNo.
C1309

Dmin 50 1 {1 mm} 10000 Minimum diameter, function
block DCALC1
 8.2-1
C1310 DCALC1-Titime 0.000 0.000 {0.001
s}
999.900 Acceleration and deceleration
time, function block DCALC1
C1311 window D-calc 1.00 0.00 {0.01 %} 100.00 Window - diameter calculation,
function block DCALC1
z Window setting for permissible
diameter deviation
C1320

CFG: SET 1000 FIXED0%  Selection list 1 Configuration of analog input
signal, function block DCALC1
z Setting the initial value
 8.2-1
C1321

 Selection list 2 Configuration of digital input
signals, function block DCALC1
1 CFG: LOAD 1000 FIXED0 z HIGH: Initial value at
DCALC1-SET is accepted
z DCALC1-LOAD has a higher
priority than DCALC1-HOLD
2 CFG: HOLD 1000 FIXED0 z HIGH = Keeps the achieved
diameter and resets the
integrators.
C1322 -36000 {1 rpm} 36000
Function block DCALC1
z Display of the signals linked in
C1327
 8.2-1
1 DIS: N-Line
2 DIS: N-WIND
C1325 DIS: SET -199.99 {0.01 %} 199.99 Function block DCALC1
z Display of the signal linked in
C1320
C1326 0 1
Function block DCALC1
z Display of the signals linked in
C1321
1 DIS: LOAD
2 DIS: HOLD
C1327

 Selection list 3 Configuration of input signals,
function block DCALC1
 8.2-1
1 CFG: N-Line 1000 FIXED0INC z Speed signal of the line drive
2 CFG: N-WIND 1000 FIXED0INC z Speed signal of the winding
drive
C1328 DIS: D-ACT -200 {1 mm} 200 Function block DCALC1
z Display of the current diameter
The signal at DCALC1-Set is s et as initital value.
ƒ The initial value is accepted with DCALC1-LOAD = 1.
ƒ The initial value is accepted without being filtered.
Setting the initial value

Lenze 9300 vector Series Specifications

General

Brand	Lenze
Model	9300 vector Series
Category	DC Drives
Language	English