Wiring the standard device
Control connections
With active ”safe standstill” function
5
5.9
5.9.2
5.9-3
EDSVF9333V EN 3.0-06/2005
5.9.2 With active ”safe standstill” function
ƒ Only qualified personnel are permitted to install and set up the “Safe
standstill” function.
ƒ All safety-relevant cables (e. g. control cable for the safety relay,
feedback contact) outside the control cabinet must be protected, for
instance, by a cable duct. Short circuits between the single cables must
be ruled out!
ƒ Wiring of the safety relay K
SR
with insulated wire end ferrules or rigid
cables is absolutely vital.
ƒ The electrical reference point for the coil of the safety relay K
SR
must be
connected with the protective conductor system (DIN EN 60204-1
paragraph 9.4.3). Only this measure guarantees that the operation is
protected against earth faults.
Tip!
A complete description of the ”Safe standstill” function can be
found in chapter ”Safe standstill”.
Safety instructions for the
installation of the ”safe
standstill” function
To Next Page
Loading...
Need help?
General