Commissioning
Parameter setting with the XT EMZ9371BC keypad
Commissioning example in vector control mode
6
6.3
6.3.2
6.3-8
EDSVF9333V EN 3.0-06/2005
NoteSwitch-on sequence
26. The drive is running now CW rotation:
X5/E1 = HIGH and X5/E2 = LOW
CCW rotation:
X5/E1=LOWandX5/E2=HIGH
If the drive does not start, press in
addition
(see chapter ”Commissioning” →
”Acceleration, deceleration, braking,
stopping”)
Note!
In the menu ”Diagnostic” the most important drive parameters
can be monitored
To Next Page
Loading...
Need help?
General