Configuration
Code table
8
8.3
8.3-15
EDSVF9333V EN 3.0-06/2005
IMPORTANTPossible settingsCode
SelectionLenzeNameNo.
C0146 fly current 0 -500 {1} 500 Flying restart circuit, quantity of
current during search process
z Influences the current
injection during search process
8.2-25
8.2-48
C0147 fly dt-f 0 -82 {1} 82 Flying restart circuit, search speed
during flying restart process
z For drives with great
centrifugal masses, reduce the
search speed, if required
C0148
ident run 0
0 WRK
stop
Ready
Motor data identification
1. Inhibit controller, wait until
drive has stopped
2. Enter the correct values of the
motor nameplate into C0087,
C0088, C0089, C0090, C0091
3. Set C0148 = 1, confirm with
4. Enable controller
The identification
–starts, goes off. The
motor ”whistles” but does
not rotate!
– lasts approx. 1 ... 2 min
– is completed when is lit
again
5. Inhibit controller:
6.6-13
1 WRK
run
Start identification
C0149
Auto ident 0
0 Id
inactive
Automatic identification is
inactive
Automatic motor data
identification
1. Inhibit controller, wait until
drive has stopped
2. Enter the correct values of the
motor nameplate into C0087,
C0088, C0089, C0090, C0091
3. Set C0149 = 1, confirm with
4. Enable controller
The identification
–starts, goes off. The
motor ”whistles” but does
not rotate!
– lasts approx. 1 ... 2 min
– is completed when is lit
again
5. Inhibit controller:
6.6-13
1 Id active Automatic identification is
active
z The identification starts
automatically after
controller enable
z After a faulty
identification, the
process is restarted after
TRIP RESET or mains
switching and
subsequent controller
enable
C0150 Status word
Bit00 – Bit08 Status Code
Read only
Decimal status word when
networked via automation
interface (AIF)
z Binary interpretation indicates
the bit states
See System
Manual
(extension)
Bit01 IMP Bit09 Status Code
Bit02
– Bit10 Status Code
Bit03
– Bit11 Status Code
Bit04 – Bit12 Warning
Bit05
– Bit13 Message
Bit06
n=0 Bit14 –
Bit07
CINH Bit15 –
C0151
DIS: FDO (DW) Read only
z Free digital outputs (FDO)
z Hexadecimal representation of
the digital output signals
configured in C0116
z Binary interpretation indicates
the bit states
See System
Manual
(extension)
To Next Page
Loading...
Need help?
General