Lenze i510 Series

Performing opmisaon with keypad
Since there is no access with the keypad to the motor catalogue, rst the motor data must be
set manually with the keypad according to the manufacturer data/motor data sheet. 4Man-
ual seng of the motor data ^ 114
The following ow diagram shows the opmisaon process with the keypad:
Yes
Yes No
No
No
End
d)
Automatic motor calibration
(non-energized)
c)
Automatic motor identification
(energized)
Set manually:
• Motor data (e.g. according to data on
the motor nameplate)
• Motor control type
• Mechanical load and its coupling
to the motor
• Filter time for speed feedback
Lenze motor
connected?
Identification
(energized)
possible?
Engineering tool
available?
Start
c) If the applicaon enables you to energise the system during the opmisaon procedure, carry out an automac idencaon. This proce-
dure results in the best possible parameter sengs.
4Automac motor idencaon (energized) ^ 146
d) If the applicaon does not enable you to energise the system during the opmisaon procedure, carry out an automac calibraon.
4Automac motor calibraon (non-energized) ^ 147
Motor control
Opmisaon of the control loops
142