Lenze i510 Series - Technical Data; Standards and Operating Conditions; IT System Connection

11 Addional funcons 248
11.1 Device Commands 249
11.1.1 Reset parameters to default 249
11.1.2 Saving/loading the parameter sengs 250
11.1.3 Device commands for parameter change-over 252
11.1.4 Delete logbook 252
11.2 Keypad 253
11.2.1 Keypad language selecon 253
11.2.2 Keypad setpoint increment 253
11.2.3 Keypad scaling of speed display 253
11.2.4 Keypad status display 253
11.2.5 Keypad - Conguraon of R/F and CTRL buons 254
11.3 Wireless LAN (WLAN) 257
11.3.1 WLAN LED status displays 257
11.3.2 WLAN basic sengs 258
11.3.2.1 Reseng WLAN sengs to default seng 260
11.3.3 WLAN access point mode 261
11.3.3.1 Establishing a direct WLAN connecon between smartphone and inverter 262
11.3.3.2 Using the smartphone as "Smart Keypad" 263
11.3.3.3 Establishing a direct WLAN connecon between Engineering PC and inverter 264
11.3.4 WLAN client mode 266
11.4 DC braking 268
11.4.1 Example 1: Automac DC braking when the motor is started 270
11.4.2 Example 2: Automac DC braking when the motor is stopped 271
11.4.3 Migraon of Lenze Inverter Drives 8200/8400 273
11.5 Brake energy management 274
11.5.1 Stopping the deceleraon ramp funcon generator 275
11.5.2 Inverter motor brake 276
11.6 Load loss detecon 277
11.7 Access protecon 278
11.7.1 Write access protecon 278
11.7.1.1 Write access protecon in the »EASY Starter« 280
11.7.1.2 Write access protecon in the keypad 283
11.8 Favorites 287
11.8.1 Accessing the "Favorites" with the keypad 287
11.8.2 Favorites parameter list (default seng) 288
11.8.3 Conguring the "Favorites" 289
11.9 Parameter change-over 292
11.9.1 Example: Selecve control of several motors with one inverter 295
11.10 Device prole CiA 402 297
11.11 Holding brake control 300
11.11.1 Basic seng 301
11.11.2 "Automac" brake mode (automac operaon) 302
11.11.3 Brake holding load 304
11.11.4 Brake closing level 306
11.11.5 Manual release of the holding brake 308
11.12 Flying restart circuit 309
11.13 Timeout für fault reacon 311
11.14 Automac restart 312
Contents
7