Lenze i550

6 EtherNet/IP
Configuration
Lenze · Inverter i550 - Cabinet · Ethernet Manual · 0.1 EN · 12/2015 29
P510:2
0x23A1:2
Subnet (*)
i550
R/W
-- ... [255.255.255.0] ... --
EtherNet/IP Subnet mask
P510:3
0x23A1:3
Gateway (*)
i550
R/W
-- ... [0.0.0.0] ... --
EtherNet/IP Gateway address
P510:4
0x23A1:4
Host name (*)
i550
R/W
-- ... [--] ... --
Setting the host name
Note: As DNS is not supported the hostname only serves to identify the
device.
P510:5
0x23A1:5
IP configuration (*)
i550
R/W
0: Stored IP
1: BOOTP
2: DHCP
Specifies the way getting/acquiring the used Network address configura-
tion.
P510:6
0x23A1:6
Multicast TTL (*)
i550
R/W
-- ... [1] ... --
Multicast TTL
By default mechanism, this MC IP address is calculated by Ethernet/IP
algorithm from defined unicast IP address.
If desired, this can be set manually using the following drive parameters.
P510:7
0x23A1:7
Multicast allocation control (*)
i550
R/W
0: Default Allocation Algorithm
1: NumMcast/Mcast start addr
Allocation Control
P510:8
0x23A1:8
Mcast IP address (*)
i550
R/W
-- ... [239.64.2.192] ... --
IP Address setting for Multicast
P510:9
0x23A1:9
Multicast number (*)
i550
R/W
1 ... [1] ... 8
P510:10
0x23A1:10
Timeout (*)
i550
R/W
500 ... [10000] ... 65535 ms
Ethernet timeout in ms
P512:1
0x23A4:1
Port 1 enum (*)
i550
R/W
0: Auto-Negotiation
1: 10Mbps
2: 100Mbps
5: 10Mbps/Half Duplex
6: 10Mbps/Full Duplex
7: 100Mbps/Half Duplex
8: 100Mbps/Full Duplex
Ethernet Port 1 Settings
P512:2
0x23A4:2
Port 2 enum (*)
i550
R/W
0: Auto-Negotiation
1: 10Mbps
2: 100Mbps
5: 10Mbps/Half Duplex
6: 10Mbps/Full Duplex
7: 100Mbps/Half Duplex
8: 100Mbps/Full Duplex
Ethernet Port 2 Settings
P513:0
0x23A6:0
Quality of service (*)
i550
R
0: 802.1Q Tag disable
1: 802.1Q Tag enable
Enable/disable VLAN tagging 802.1Q
P514:0
0x23A7:0
Address conflict detection (*)
i550
R/W
0: Disabled
1: Enabled
Enable or disable address conflict detection