Lenze i550

1 About this manual
Purpose of this manual
4 Lenze · Inverter i550 - Cabinet · Ethernet Manual · 0.1 EN · 12/2015
1 About this manual
This manual
 applies to the i550 inverter series
 contains important technical information for the commissioning of EtherCAT, PROFINET and EtherNet/IP
i
PROFINET and EtherCAT are supported from SW Version 02.00
EtherNet/IP is supported from SW Version 02.01
1.1 Purpose of this manual
The purpose of this manual is to provide all necessary information for the setup of EtherCAT, PROFINET and
EtherNet/IP of the i550 inverters.
1.2 Reference to other documents
Beside the operation manual the following documents are also required for the safe installation, commissioning
and operation of the inverter:
 i500 Operation manual
 i500 Reference/Commissioning manual
 i500 Mounting and switch-on instructions
 Easy Starter software documentation
i
For general commissioning and setup refer to the i500 Operation manual or the i500 Refer-
ence/Commissioning manual.
1.3 Copyright
© 2015 Lenze Drives GmbH
All rights reserved. All information and illustrations contained in this operation manual are the property of Lenze
Drives GmbH and may not be used in any manner harmful to their interests.
1.3.1 Manufacturer’s address
Lenze Drives GmbH
Postfach 10 13 52, D-31763 Hameln
Breslauer Straße 3, D-32699 Extertal
Germany
HR Lemgo B 6478
Phone: +49 5154 82-0
Fax: +49 5154 82-2800
Email: lenze@lenze.com
Web: www.lenze.com
1.4 Disclaimer of liability
The descriptions, technical data and illustrations in this operation manual are subject to change without prior no-
tice.
The procedural notes and circuit details described in this operation manual are only proposals. It is up to the user
to check whether they can be adapted to the particular applications. Lenze does not take any responsibility for
the suitability of the procedures and circuit proposals described.