LevelOne WBR-6013

To Next Page

To Previous Page

122

7. If the device PCB and the WPS handshake is successfully

doneon the station side, User’s Wi-Fi Protected status will

be shown as below.

Main Page

Default Chapter1
- User Manual1
- Table of Contents2
1 Introduction7
- Features7
- Device Requirements7
- Using this Document8
- Getting Support8
2 Getting to Know the Device9
- Computer / System Requirements9
- Package Contents9
- LED Meanings & Activations10
  - Front Panel10
  - Rear and Right Panel and Bottom Side10
- Computer Configurations under Different OS, to Obtain IP Address Automatically12
4 Connecting Your Device25
- Connecting the Hardware25
5 Advanced Configuration27
- WAN Interface Setup28
- Wirelessconfiguration32
- Wireless Connection33
6 What the Internet/Wan Access of Your Own Network Now Is34
- Internet/Wan Access Is the DHCP Client36
- Internet/Wan Access Is the Static IP37
- Internet/Wan Access Is the Pppoe Client39
7 Getting Started with the Web Pages40
- Accessing the Web Pages41
- Testing Your Setup42
- Default Device Settings43
8 Quick Setup45
- Operation Mode Setup46
- WAN Interface Setup49
- Wireless Basic Settings53
- Wireless Security Setup61
9 Operation Mode67
- Setting Operation Mode67
10 Wireless Network - WLAN168
- Basic Settings68
- Advanced Settings71
- Security72
- Access Control79
  - Allow Listed80
  - Deny Listed81
- WDS Settings82
  - Configurewds (Wireless Distribution System) Only83
  - Configureap (Access Point) + WDS (Wireless Distribution System)87
- Site Survey92
  - Configurewireless ISP + Wireless Client +Site Survey93
- Wps97
- Operations of AP - AP Being an Enrollee102
- Operations of AP - AP Being a Registrar116
  - AP Mode116
  - Push Button Method120
- Wireless Schedule124
11 LAN Interface125
- LAN Interface Setup125
- Changing the LAN IP Address and Subnet Mask127
- Show Client130
12 WAN Interface131
- Configuring Static IP Connection135
- Configuring DHCP Client Connection137
- Configuring Pppoe Connection140
- Configuring PPTP Connection143
- Configuring L2TP Connection147
- Configuring L2TP Connection150
- Clone MAC Address151
13 Ipv6155
- Ipv6 Wan Setting155
- Ipv6 Lan Setting156
- Radvd157
- Tunnel (6 over 4)159
14 Port Filtering160
- Port Filtering for TCP Port 80161
- Port Filtering for UDP Port 53163
15 IP Filtering165
- IP Filtering for TCP with Specified IP166
- IP Filtering for UDP with Specified IP168
- IP Filtering for both TCP and UDP with Specified IP169
16 MAC Filtering172
- MAC Filtering for Specified MAC Address173
17 Port Forwarding175
- Port Forwarding for TCP with Specified IP177
- Port Forwarding for UDP with Specified IP178
18 URL Filtering180
- URL Filtering for Specified URL Address181
19 Dmz183
- DMZ Host IP Address183
- 802.1Q Vlan185
20 802.1Q Vlan186
21 Route Setup186
22 Qos187
23 Status188
24 Statistics190
25 Dynamic DNS191
- Configure Dyndns193
- Configure TZO195
26 Time Zone Setting197
- SNTP Server and SNTP Client Configuration Settings197
27 Denial-Of-Service199
28 Log201
- System Log201
29 Firmware Update204
- About Firmware Versions204
- Manually Updating Firmware204
30 Save/Reload Settings206
- Save Settings to File206
- Load Settings from File208
- Resetting to Defaults210
31 Password212
- Setting Your Username and Password212
- Configuring Your Computers214
  - Configuring Ethernet Pcs214
- IP Addresses, Network Masks, and Subnets219
  - IP Addresses219
    - Structure of an IP Address219
    - Network Classes219
  - Subnet Masks220
- Upnp Control Point Software on Windows ME/XP222
  - Upnp Control Point Software on Windows ME222
  - Upnp Control Point Software on Windows XP with Firewall223
    - SSDP Requirements223
- Troubleshooting226
  - Troubleshooting Suggestions226
  - Diagnosing Problem Using IP Utilities228
    - Ping228
    - Nslookup228
- License Statement / Gpl Code Statement230

LevelOne WBR-6013 - Page 122

Table of Contents

Other manuals for LevelOne WBR-6013

Related product manuals